Integration module for the Ajax MultiTransmitter security system
Advanced security systems require the use of modern communications that are capable of performing complex tasks and providing high-level protection to the user. If the alarm system is outdated, it needs to be updated. To do this, it is not necessary to completely replace all alarm devices and change a large number of wires. You can add several Ajax devices to the security system, which transform the old system into a new generation security alarm system with convenient control from the user's mobile phone and advanced protection technologies. In order to add third-party wired sensors to the Ajax wireless control panel, the Ajax MultiTransmitter integration module is used, which operates at a frequency of 868.0-868.6 MHz and has 18 alarm zones. The integration radio module interacts with the intelligent center in an open area without interference at a distance of up to 2000 meters, and indoors – between several floors. The broadcast signal is protected by encryption for secure transmission of information. To check the transmitter's operability, the control panel polls the device every 12-300 seconds. The frequency is individually adjusted by the user. The power supply of the integration module for signaling comes from a 100-240 V AC network. The transmitter can operate independently from a 12 V backup battery for up to 4 days. In addition, the integration radio module is capable of providing 12V power to the sensors of the system. The transmitter board has terminals for connecting alarm zones and for powering fire sensors.
Purpose of the integration radio module for Ajax MultiTransmitter signaling
MultiTransmitter is able to transform a wired alarm system into a modern and reliable security system with the ability to control it through a mobile application, as well as replace the old control panel. The Ajax alarm transmitter is designed to connect third-party wired devices to the Ajax wireless security system devices. Together with other Ajax devices, the MultiTransmitter integration module increases the level of comfort and safety and ensures reliable operation of not only fire and burglar alarms, but also smart home systems.
Features of the Ajax MultiTransmitter Integration module
The Ajax alarm system radio network is capable of covering up to 35 km2 using ReX signal repeaters. And if part of the premises is impervious to radio waves, the MultiTransmitter wireless integration module will be the optimal solution for adding wired sensors to the system. The Ajax wireless transmitter is connected to the alarm control panel (Hub, Hub Plus, Hub 2, Hub 2 Plus) via the Jeweller radio protocol. Alarm from a sensor connected by NC/NO contacts (supports contact types NO, NC (without R), EOL (NC with R), EOL (NO with R)) it is transmitted directly to the intellectual central. The wireless alarm module can be integrated with outdoor or indoor detectors of vibration, movement, glass breaking, opening, thermal relay, IR barriers, gas and water leakage sensors, as well as with other third-party security devices, which will turn them into full-fledged Ajax security system devices. All 18 wired zones can be configured in the Ajax mobile app. Sensors connected to the zones can operate around the clock in security mode with a delay for entry or exit, and, if necessary, participate in automation scenarios and activate sirens. The maximum length of the wired connection of the detector with a cable is up to 400 m. The integration radio module can be a power source for the connected device – 12 V DC to 1 A for all power outputs of the detectors. If the connection to the wired device is lost, the user alarm will be immediately notified. Setup and testing of the MultiTransmitter wireless integration module takes place in the Ajax mobile application. Connection to the security system is carried out after scanning the QR code on the device body. When connecting wired devices, you do not need to know the resistance value of the resistors. If the device was connected incorrectly, the security system will warn you about the error. All notifications and alarms are sent to the alarm owner's mobile phone by SMS messages or push notifications. There are five types of alarms: fire alarm, gas alarm, intrusion, medical assistance, alarm button. For each wired device, you can configure the alarm type and the placement room. This information is indicated in the alarm notification, and is also sent to the remote control of the security company under the code. This increases the information content of the messages, since the user will know exactly where and what happened.
